Fiber optic-Switch for ethernet ring, multimode

583392

Approval: G 210122
Part of EN 54-16 approval 0786-CPD-20997


The LWL-Switch is used for designing an ethernet network in loop topology. On account of the loop structure, the network is fully redundant since, in the case of an LWL fiber rupture, it is possible to still communicate through the other side of the loop. In addition, every switch has two operating voltage inputs (24 V DC) and one relay for the forwarding of fault signals.
  • Approved as per EN 54-16
  • 6 Ethernet-connections
  • Relay for redirecting a faulty message contact load 24 V DC / 1 A
  • 2 Duplex-SC-LWL-connections

Standards
  • IEEE 802.3 10Base-T
  • IEEE 802.3u 100Base-TX/FX
  • IEEE 802.1p Priority Support
  • IEEE 802.1d Spanning Tree Protocol
  • IEEE 802.1w Rapid Spanning Tree
  • IEEE 802.1q VLAN Tagging
Operating voltage12 ... 48 V DC
FiberMultimode 50/125 ?m, 62,5/125 ?m
Channel separation> 75 dB
Harmonic distortion at nominal level@ 1 kHz
Power consumption6 W
Type of protectionIP30
Transmission distancemax. 2 km
Data transmission speed14880 / 148800 bps (Ethernet / Fast Ethernet)
Ambient temperature0 °C ... 60 °C
DimensionsW: 54 mm H: 135 mm D: 105 mm